9
6. Installation
1.
The device has a built-in magnet.
When installed, it can be attached to the surface of an
object with iron which is convenient and quick.
To make the installation more secure, use screws
(purchased) to secure the unit to a wall or other surface
Note:
Do not install the device in a metal shielded box or in an
environment with other electrical equipment around it to
avoid affecting the wireless transmission of the device.
2. Fix the vibration sensor of the vibration sensor on the
object that needs to be detected whether it is vibrating
(here, take the mousetrap as a picture, as shown below).
3.The figure shows the vibration sensor (R718DA)
applied to the scene of the mousetrap in the restaurant.
It can also be applied to the following scenarios:
●
Restaurant (rat)
●
Shopping mall supermarket (rat)
●
Engine room (rat)
When it is necessary to detect whether the object is
vibrating or moved.
4. When the vibration sensor detects a vibration, it
immediately sends an "alarm" message.
When the device reports data periodically, it restores
the "normal" status and sends "normal" status
information. Moreover, enable the Restore function
and the “normal” status will be sent after the device
stops for 5 seconds.
Note:
The shaking alarm bit is “1”.
The static and non-shaking alarm bit is “0”.
