5
Sleeping Mode
The device is turn on and join
in the network
Sleeping period: Min Interval.
When the reportchange exceeds the default or the state of the device changes: send a data report
according to Min Interval.
Low Voltage Warning
Low Voltage
2.4V
*Suggest removing batteries if the device is not used to save power.
5. Data Report
After power on, the device will immediately send a version packet report and a data report including temperature, humidity,
and voltage.
The device sends data according to the default configuration before any other configuring.
Default setting:
Report MaxTime
：
1 H (3600s)
Report MinTime
：
1 H (3600s) (Default: Every Min Interval will detect the state of the dry contact one time)
BatteryVoltageChange
：
0x01 (0.1V)
Triggering the dry contact:
When the dry contact detects the state changing, the report will be sent immediately.
Open: 1
Close: 0
Note:
1. The cycle of the device sending the data report is according to the default.
2. The interval between two reports must be the MinTime.
The device reported data parsing please refer to
Netvox LoraWAN Application Command document
and
Netvox Lora
Command Resolver
http://loraresolver.netvoxcloud.com:8888/page/index
Data report configuration and sending period are as following
：
Min Interval
(Unit: second)
Max Interval
(Unit: second)
Reportable Change
Current Change ≥
Reportable Change
Current Change
＜
Reportable Change
Any number between
1~65535
Any number between
1~65535
Can not be 0
Report per Min Interval Report per Max Interval
