28
My-Netti.com
6.17 ADJUSTING THE BRAKES
• The brakes are freely adjustable along the
frame tube.
• To activate the brake, push the handle
forward
Model:
Netti III and Netti III HD
Language:
English
Version:
2017-06
• To release the brake, pull the handle
rearwards
• To reposition the brake, loosen the two
screws on the
inside of the brake
clamp
• For fine adjustment, loosen the upper
screw on the inside of the brakes
• Adjust the brake position and
tighten the
screws.
5 mm
Allen key
Adjusting the head support sideways:
• The head support adapter can be
moved both to the right and left,
giving the possibility to accommodate
special needs for head support.
• Untighten the four screws holding the
adapter together.
• Move the adapter to the required
position and fix the adapter by
tightening the screws diagonally.
Remember to release the levers when
adjusting the head support.
If the head support stand does not fit
the bracket perfectly the bracket is
probably fixed too tight or unevenly.
After fitting the head support, fix it
properly by tightening the little set screw
in the centre on top of the head support
bracket using an Allen-key.
If the head support seems too short in
height, it can be turned 180° by releasing
the adjustment wheel at the rear of the
horizontal bar (B) .
6.16 PUSH HANDLES
Adjustment of push handles:
• Release the lever on the side and lift
the handle all the way up.
• Turn the handles into required position.
• Adjust height.
• Lock the handle in required position by
tightening the lever.
Check that the safety screw is
properly tightened.
To remove the handles, the safety screw
at the bottom of the handles also
has to be removed.
