1. Connect one end of power cord to the power cord receptacle at rear of
NS780S-G3 enclosure, and the other end of power cord to the power outlet.
2. Press and hold NS780S-G3 storage’s front LED button for over two seconds
until the LED button turns blue light to power on the Netstor unit. And
then power on your host computer.
3. After the computer is shut down, press and hold NS780S-G3 enclosure’s
front LED button for over two seconds until the LED button shows no
light to power off the storage.
6.2 Power on/off manually
(go to
page 20.
to set SW1-4 to OFF for effect)
13
1. Hold for over two seconds
2. Hold LED button for over two seconds
1. Host computer shut down
2. Power on your host computer