Netscout OneTouch AT 10G, User Manual

Page: 209 / 248

Chapter 9: Packet Capture
AutoTest Capture
207
Note
Do not remove the SD card from the OneTouch
analyzer until the
START CAPTURE
button re-appears.
Failure to wait for the
START CAPTURE
button to re-
appear may result in loss or corruption of SD card
data.
AutoTest Capture
The OneTouch AT 10G analyzer can capture traffic to and from
the analyzer during AutoTest. The capture file can be examined
to obtain detailed troubleshooting information.
When AutoTest Capture is enabled, each time you run AutoTest
the analyzer captures wired traffic to and from the analyzer. If
you don’t save the capture, it is overwritten the next time you run
AutoTest.
To Enable or Disable AutoTest Capture
1 Tap the TOOLS icon on the HOME screen.
2 Tap the Capture button.
3 In the AutoTest Capture section, set Enable to On.
The setting is stored in the Profile.
To Save an AutoTest Capture
1 Run AutoTest.
2 When AutoTest completes, tap the OneTouch AT 10G button
at the upper right corner of the HOME screen.
3 Tap the Save AutoTest Capture button.
Note
This button only appears when AutoTest Capture is
enabled and AutoTest has completed. The same
button appears on the CAPTURE screen in the TOOLS
menu.