All AirCheck G2 Settings
99
Thresholds
The Thresholds screen allows you to set the threshold values the Tester uses to rate the quality of performance or service. The
quality categories are pass/warning/fail or
green
/
yellow
/
red
. You can adjust the range of values represented by
green
,
yellow
,
and
red
to your preference. For instance, you can eliminate the range of
yellow
altogether by increasing the ranges or values of
green
and
red
.
Threshold Setting
Description
Associated Tester Screens
Signal Thresholds
Signal Strength
Determines
green
/
yellow
/
red
indications for received signal
strength measurements from APs.
This threshold is also used for
Signal Level
color ratings.
Networks List and Network Details, AP
List and AP Details, Channel Details,
Clients List and Client Details, Connect
to Network and Connect to AP
Noise
Determines
green
/
yellow
/
red
indications for measured
noise levels on the channel of an AP.
Network Details, AP Details, Connect to
Network and Connect to AP
SNR
Determines
green
/
yellow
/
red
indications for the Signal-to-
Noise Ratio based on measured signal and noise levels.
Networks List and Network Details, AP
List and AP Details, Connect to
Network and Connect to AP
Air Quality Thresholds
Channel 802.11
Utilization
Percentage of airtime utilization of all 802.11 WLAN traffic on a
channel.
AutoTest Air Quality
Channel non-802.11
Utilization
Percentage of airtime utilization of all non-802.11 interference
on a channel. These may be non-WLAN interference sources.
AutoTest Air Quality
Co-Channel
Interference
Number of APs on a same channel. These same thresholds are
used for Adjacent Channel Interference in the 2.4-GHz band.
AutoTest Air Quality
AP Signal Level
The minimum signal level at which an AP must be measured to
be counted in Co-Channel and Adjacent Channel Interference
measurements.
AutoTest Air Quality
