NetModule NB3710, User Manual

Page: 64 / 211

NB3710 User Manual 4.0
Running a device server, the following settings can be applied:
Figure 5.18.: Serial Port Settings
Parameter Serial Settings
Physical protocol Selects the desired physical protocol on the serial port
Baud rate Specifies the baud rate run on the serial port
Data bits Specifies the number of data bits contained in each frame
Parity Specifies the parity used for every frame that is transmitted
or received
Stop bits Specifies the number of stop bits used to indicate the end
of a frame
Software flow control Defines the software flow control for the serial port,
XOFF
will send a stop,
XON
a start character to the other end to
control the rate of any incoming data
Hardware flow control You may enable RTS/CTS hardware flow control, so that
the RTS and CTS lines are used to control the flow of data
64