WF-2405
User Manual
56
5.7.
System Tools
Please refer to chapter 3.13 .
5.8.
About
Please refer to chapter 3.14 .
Note:
After finishing configure WF-2405, please return to your computer to change the IP
address. You can use static IP or obtain an IP automatically.
Figure 5-7
6.
Troubleshooting
6.1.
I cannot access the Web-based Configuration Utility from the Ethernet
computer used to configure the router.
Check that the LAN LED is on. If the LED is not on, verify that the cable for the LAN
connection is firmly connected.
Check whether the computer resides on the same subnet with the router
‟
s LAN IP address.
If the computer acts as a DHCP client, check whether the computer has been assigned an
IP address from the DHCP server. If not, you will need to renew the IP address.
Use the ping command to ping the router
‟
s LAN IP address to verify the connection.
Make sure your browser is not configured to use a proxy server.
Check that the IP address you entered is correct. If the router
‟
s LAN IP address has been
changed, you should enter the reassigned IP address instead.
