19
4.6
Restoring factory defaults
This operation deletes all user settings and restores the configuration to the factory defaults. It is
useful when the device is in an unknown state or does not behave as described in this manual.
Procedure:
1.
Turn off the PowerDIN 4PZ.
2.
Remove the top plate with green label – the button “DEFAULT” is on the left side.
3.
Press and hold the button.
4.
Connect the device to the power grid (button is still pushed) and wait at least 10 seconds. After
green LED OUTPUTS blinks, release the button.
5.
The device reverts to factory settings and the AP mode is activated (if no Ethernet cable
connected).
Forgotten password
The reset to factory defaults is also used when the password has been forgotten. After
restoring the factory defaults, the username and password to access the PowerDIN 4PZ
will be “
admin
” / “
admin
”.
4.7
Controlling the output manually
The outputs can be switched on/off (toggled) by pressing the button quickly 3 times in a row.
The use of this feature is recommended only for troubleshooting etc.
1.
Remove the top plate with green label – the button “DEFAULT” is on the left side.
2.
Press the “DEFAULT” button three times fast to toggle the outputs.
Note: If at least one output is ON the “toggle” by button change all outputs to OFF. If all outputs
are OFF the “toggle” change all to ON.