LED behavior
When you sync an Orbi Pro WiFi 6 AX5400 satellite to the Orbi Pro WiFi 6 AX5400
router, the LED behavior for a satellite that comes in an Orbi Pro WiFi 6 AX5400 system
is different from the LED behavior for add-on Orbi Pro WiFi 6 AX5400 satellites.
Orbi Pro WiFi 6 AX5400 System LEDs
The following table describes the LED behavior for an Orbi Pro WiFi 6 AX5400 router
(model SXR50) and Orbi Pro WiFi 6 AX5400 satellite (model SXS50) that are purchased
together and come in the same package.
Table 1. Orbi Pro WiFi 6 AX5400 System router and satellite LED descriptions
LED Behavior
LED
The Power LED is located adjacent to the power connector on the rear panel.
• Solid green: Power is on.
• Solid amber: The router or satellite is booting.
• Blinking amber: The router or satellite is resetting to factory default settings.
• Blinking red: The firmware is corrupted.
• Off: Power is not supplied.
Power LED
The bar LED is located on the front.
• Pulsing white: The router is booting or someone pressed the Sync button.
• Off: The router finished booting and is working normally.
• Solid white: The router is resetting to factory default settings.
• Solid magenta: The router cannot connect to the Internet. See You cannot access the
Internet on page 208.
Router bar LED
This satellite is included when you buy an Orbi router. The bar LED is located on the front.
• Pulsing white: The satellite is booting.
• Blue for three minutes: The connection between the satellite and the router is good.
• Amber for three minutes: The connection between the satellite and the router is fair.
• Magenta: The satellite failed to sync to the router. See The router and satellite do not
sync on page 206.
• Off: The satellite synced to the router and is working normally.
Satellite bar
LED
User Manual
13
Overview and Setup
Orbi Pro WiFi 6 AX5400 Router Model SXR50 and Orbi Pro WiFi 6 AX5400 Satellite Model SXS50
