7000 Series L3 Managed Switch Reference Manual for Software v1.0
7-26
Switching Commands
May 30, 2003 Beta Draft
show port
This command displays port information.
Format
show port
<slot.port|all>
Slot.Port
The physical slot and physical port.
Type
If not blank, this field indicates that this port is a special type of
port. The possible values are:
Mon
- this port is a monitoring port. Look at the Port Monitoring
screens to find out more information.
Lag
- this port is a member of a Lag. Look at the Lag screens to
find out more information.
Probe
- this port is a probe port. Look at the Port Mirroring
screens to find out more information.
Admin Mode
Selects the Port control administration state. The port must be
enabled in order for it to be allowed into the network. - May be
enabled or disabled by selecting the corresponding line on the
pull-down entry field. The factory default is enabled.
Physical Mode
Selects the desired port speed and duplex mode. If auto-negotia-
tion support is selected, then the duplex mode and speed will be
set from the auto-negotiation process. Note that the port's maxi-
mum capability (full duplex -100M) will be advertised. Other-
wise, this object will determine the port's duplex mode and
transmission rate. The factory default is Auto.
Physical Status
Indicates the port speed and duplex mode.
Link Status
Indicates whether the Link is up or down.
Link Trap
This object determines whether or not to send a trap when link
status changes. The factory default is enabled.
LACP Mode
Displays whether LACP is enabled or disabled on this port.
config port adminmode
This command enables or disables a port.
Default
enable
Format
config port adminmode
<slot.port|all>
<enable|disable>
Summary of Contents for ProSafe GSM7324
Page 4: ...May 30 2003 Beta Draft iv...