7000 Series L3 Managed Switch Reference Manual for Software v1.0
Switching Commands
7-15
May 30, 2003 Beta Draft
show network
This command displays network configuration settings that are vital for switch operation.
Format
show network
IP Address
The IP address of the interface. The factory default value is
0.0.0.0
Subnet Mask
The IP subnet mask for this interface. The factory default value is
0.0.0.0
Default Gateway
The default gateway for this IP interface. The factory default
value is 0.0.0.0
BurnedIn MAC Address
The burnedin MAC address used for in-band connectivity.
Network Configuration Protocol Current
Indicates which network protocol is being used. The
options are bootp|dhcp|none.
Web Mode
Specifies if the switch should allow access from a web browser.
Enabled means the switch can be managed from a web browser.
The factory default is enabled.
Java Mode
Specifies if the switch should allow access to the Java applet in
the header frame. Enabled means the applet can be viewed. The
factory default is enabled.
config network parms
This command sets the IP Address, subnet mask and gateway of the router. The IP Address and the
gateway must be on the same subnet.
Format
config network parms
<
ipAddr
>
<netmask>
[gateway]
config network protocol
This command specifies the network configuration protocol to be used. If you modify this value
change is effective immediately.(See “save config” on page 63.)
Default
none
Format
config network protocol
<none|bootp|dhcp>
,
where
bootp
indicates that the switch periodically sends
requests to a Bootstrap Protocol (BootP) server or a dhcp server
until a response is received.
none
indicates that the switch
should be manually configured with IP information.
Summary of Contents for ProSafe GSM7324
Page 4: ...May 30 2003 Beta Draft iv...