7000 Series L3 Managed Switch Reference Manual for Software v1.0
Routing Commands
8-19
May 30, 2003 Beta Draft
show router ospf neighbor table
This command displays the OSPF neighbor table list. When a particular neighbor ID is specified,
detailed information about a neighbor is given. The information below will only be displayed if
OSPF is enabled.
Format
show router ospf neighbor table
<slot.port>
Router ID
Is 4 digit dotted decimal number representing the neighbor inter-
face.
IP Address
Is an IP address representing the neighbor interface.
Neighbor Interface Index
Is a slot.port identifying the neighbor interface index.
show router ospf stub table
This command displays the OSPF stub table. The information below will only be displayed if
OSPF is initialized on the switch.
Format
show router ospf stub table
Area ID
Is a 32-bit identifier for the created stub area.
Type of Service
Is the type of service associated with the stub metric. The
GSM7324 L3 Switch only supports Normal TOS.
Metric Val
The metric value is applied based on the TOS. It defaults to the
least metric of the type of service among the interfaces to other
areas. The OSPF cost for a route is a function of the metric value.
Metric Type Is the type of metric advertised as the default route.
Import Summary LSA Controls the import of summary LSAs into stub areas.
show router ospf lsdb summary
This command displays the link state database. This command takes no options. The information
below will only be displayed if OSPF is enabled.
Format
show router ospf lsdb summary
Router ID
Is a 32 bit dotted decimal number representing the LSDB inter-
face.
Area ID
Is the IP address identifying the router ID.
LSA Type
The types are: router, network, ipnet sum, asbr sum, as external,
group member, tmp 1, tmp 2, opaque link, opaque area.
LS ID
Is a number that "uniquely identifies an LSA that a router origi-
nates from all other self originated LSA's of the same LS type."
Summary of Contents for ProSafe GSM7324
Page 4: ...May 30 2003 Beta Draft iv...