7000 Series L3 Managed Switch Reference Manual for Software v1.0
Routing Commands
8-13
May 30, 2003 Beta Draft
config router ospf interface interval hello
This command sets the OSPF hello interval for the specified interface.
The value for <seconds> is a valid positive integer, which represents the length of time in seconds.
The value for the length of time must be the same for all routers attached to a network.
Valid values range from 1 to 65535.
Default
10
Format
config router ospf interface interval hello
<slot.port> <1-65535>
config router ospf interface interval retransmit
This command sets the OSPF retransmit Interval for the specified interface.
The value for <seconds> is the number of seconds between link-state advertisement
retransmissions for adjacencies belonging to this router interface. This value is also used when
retransmitting database descriptions and link-state request packets.
Valid values range from 0 to 3600 (1 hour).
Default
5
Format
config router ospf interface interval
retransmit
<slot.port> <0-3600>
config router ospf interface iftransitdelay
This command sets the OSPF Transit Delay for the specified interface. In addition, it sets the
estimated number of seconds it takes to transmit a link state update packet over this interface.
Valid values for <seconds> range from 1 to 3600 (1 hour).
Default
1
Format
config router ospf interface iftransitdelay
<slot.port> <1-3600>
config router ospf interface mode
This command enables or disables OSPF on a router interface.
Summary of Contents for ProSafe GSM7324
Page 4: ...May 30 2003 Beta Draft iv...