7000 Series L3 Managed Switch Reference Manual for Software v1.0
Routing Commands
8-1
May 30, 2003 Beta Draft
Chapter 8
Routing Commands
This chapter provides detailed explanation of the Routing commands. The switch commands are
divided by functionality into these different groups:
•
Show commands are used to display switch settings, statistics and other information.
•
Config commands are used to configure features and options of the switch. For every config
command there is a show command that will display the config setting.
•
Transfer commands are used to transfer configuration and informational files to and from the
switch.
Syntax conventions are described in
Routing Commands
show arp table
This command displays the Address Resolution Protocol (ARP) cache. The displayed results are
not the total ARP entries. To view the total ARP entries, the operator should view the
show arp
table
results in conjunction with the
show arp switch
results.
Format
show arp table
Age Time (seconds)
Is the time it takes for an ARP entry to age out. This value was
configured into the unit. Age time is measured in seconds.
Response Time (seconds)
Is the time it takes for an ARP request timeout. This value was
configured into the unit. Response time is measured in seconds.
Retries
Is the maximum number of times an ARP request is retried. This
value was configured into the unit.
Cache Size
Is the maximum number of entries in the ARP table. This value
was configured into the unit.
IP Address
Is the IP assigned to each interface.
MAC Address
Is the hardware MAC address that each interface maps to.
Interface
Is the associated slot.port which identifies an ARP entry.
Summary of Contents for ProSafe GSM7324
Page 4: ...May 30 2003 Beta Draft iv...