7000 Series L3 Managed Switch Reference Manual for Software v1.0
7-56
Switching Commands
May 30, 2003 Beta Draft
config spanningtree cst port priority
This command sets the Port Priority to a new value for use within the common and internal
spanning tree. The <slot.port> is the desired switch port. The priority <value> is a number in the
range of 0 to 240 in increments of 16.
Default
128
Format
config spanningtree cst port priority
<slot.port> <0-240>
config spanningtree cst port edgeport
This command specifies if a port is an Edge Port within the common and internal spanning tree.
This will allow the port to transition to Forwarding State without delay. The <slot.port> is the
desired switch port. The edgeport <value> can either be "true" or "false".
Default
false
Format
config spanningtree cst port edgeport
<slot.port> <true/false>
config spanningtree mst create
This command adds a multiple spanning tree instance to the switch. The instance <mstid> is a
number within a range of 1 to 4094, that corresponds to the new instance ID to be added. The
maximum number of multiple instances supported by 7000 Series L3 Managed Switch Software is
4.
Format
config spanningtree mst create <mstid>
config spanningtree mst delete
This command removes a multiple spanning tree instance from the switch and reallocates all
VLANs allocated to the deleted instance to the common and internal spanning tree. The instance
<mstid> is a number that corresponds to the desired existing multiple spanning tree instance to be
removed.
Format
config spanningtree mst delete <mstid>
Summary of Contents for ProSafe GSM7324
Page 4: ...May 30 2003 Beta Draft iv...