Rear Panel
The following figure shows the rear panel connectors and buttons.
Figure 3. Rear panel
Viewed from left to right, the rear panel contains the following components:
•
LED On/Off switch. If this switch is in the Off position, all the router’s LEDs, including
the LEDs on the four active antennas, but not the Power LED, are turned off.
•
Reset button. Pressing the Reset button resets the router.
If you press the Reset button for up to 30 seconds or until the Power LED starts
blinking amber, the router returns to its factory settings. For information about the
factory settings, see Factory Settings on page 212.
•
One antenna connector.
•
Ethernet ports. Four Gigabit Ethernet RJ-45 LAN ports named Eth4 to Eth1. Use
these ports to connect the router to LAN devices.
•
Internet port. One yellow Gigabit Ethernet RJ-45 WAN port to connect the router
to an Internet modem such as a cable modem or DLS modem.
•
One antenna connector.
•
DC power connector. Connect the power adapter that came in the product package
to the DC power connector.
•
Power On/Off button. Press the Power On/Off button to provide power to the
router.
User Manual
14
Hardware Setup
XR500 Nighthawk Pro Gaming Router
