NTC-6000 Series V.250 Manual
Page 23 of 32
To suit software version 1.1.0
7/21/2010
LAN Configuration commands
The commands below are used to configure the Ethernet LAN interface. There is no error
checking beyond octet validation (Four octets of 0-255) for any of the Ethernet address
assignments. E.g. If you set the netmask to an invalid address, the modem will accept it but
may unable to transfer via the LAN interface.
^ETHI
Set the LAN Ethernet IP address
This command will set the LAN interface IP address.
Default:
192.168.20.1
Storage:
Automatic
Command values:
^
ETHI
=
<IP Address>
Sets the Ethernet IP.
^
ETHI?
Queries the current Ethernet IP.
^ETHN
Set the local Ethernet Mask
This command will set the LAN interface IP netmask.
Default:
255.255.255.0
Storage:
Automatic
Command values:
^
ETHN
=
<netmask>
Sets the Ethernet mask.
^
ETHN?
Queries the current Ethernet mask.
^ETHR
Print the Route Table
This command will print a copy of the modem‟s routing table.
Default:
N/A
Storage:
N/A
Command values:
^
ETHR?
Prints the modem‟s routing table