NTC-6000 Series V.250 Manual
Page 21 of 32
To suit software version 1.1.0
7/21/2010
zzzzz – Port to listen to in server mode.
11) APN:
Access Point Name of network to connect to.
^GASC
Enable cellular packet session auto connect
Enables or disables automatic connection and log-in to the cellular packet network.
Default:
0
Storage:
Automatic
Command values:
^GASC=0
Do not connect to cellular packet network.
^GASC=1
Connect to cellular packet network using profile 1
^GASC=2
Connect to cellular packet network using profile 2
^GASC=3
Connect to cellular packet network using profile 3
^GASC=4
Connect to cellular packet network using profile 4
^GASC=5
Connect to cellular packet network using profile 5
^GASC=6
Connect to cellular packet network using profile 6
^GRST
End Cellular Packet Session
This command will kill the current cellular packet session and bring the modem to
Command State. NOTE: This command will tear down the cellular packet session in
an orderly manner and may take several seconds to complete.
Default:
N/A
Storage:
N/A
Command values:
^
GRST
Kills the current cellular packet session.
NOTE: If
^GASC=1
, the modem will detect that the session dropped and will
immediately reconnect. To fully disconnect, set
^GASC=0
and then issue the
^GRST
command.