NetComm Wireless NTC-40WV Industrial Indoor 3G Router with Voice
/
65
Network time (NTP)
The NTP (Network Time Protocol) settings page allows you to configure the NTC-40WV router to synchronize its internal clock with
a global Internet Time server and specify the time zone for the location of the router. This provides an accurate timekeeping function
for features such as System Log entries and Firewall settings where the current system time is displayed and recorded.
Any NTP server available publicly on the internet may be used. The default NTP server is 0.netcomm.pool.ntp.org.
Figure 67 - NTP settings
Configuring Timezone settings
To configure time zone settings:
1.
The Current time field shows the time and date configured on the router. If this is not accurate, use the Time zone drop
down list to select the correct time zone for the router. If the selected zone observes daylight savings time, a Daylight
savings time schedule link appears below the drop down list. Click the link to see the start and end times for daylight
savings.
2.
When you have selected the correct time zone, click the Save button to save the settings.
Configuring NTP settings
To configure NTP settings:
1.
Click the Network time (NTP) toggle key to switch it to the ON position.
2.
In the NTP service field, enter the address of the NTP server you wish to use.
3.
The Synchronization on WWAN connection toggle key enables or disables the router from performing a synchronization of
the time each time a mobile broadband connection is established.
4.
The Daily synchronisation toggle key enables or disables the router from performing a synchronization of the time each
day.
5.
When you have finished configuring NTP settings, click the Save button to save the settings.
