9 of 22
CloudMesh Satellite – User Guide
UG01350 v1.00 14 July 2021
Pairing the CloudMesh Satellite with your
CloudMesh Gateway
Pre-configured (already paired)
If the CloudMesh Satellite and the CloudMesh Gateway have been pre-configured by your Internet Service
Provider, the devices will already have been paired together and you can turn on both devices and begin
using them.
To set up your CloudMesh Gateway and CloudMesh Satellite:
1
Turn on your CloudMesh Gateway (refer the CloudMesh Gateway User Guide) and connect to the
Internet.
2
Position the CloudMesh Satellite near the CloudMesh Gateway (refer to
CloudMesh Satellite location
section of this guide, above).
3
Connect the power adapter to the CloudMesh Satellite. The LED flashes green then starts to flash blue
after a minute or so.
4
Wait for up to 10 minutes as the CloudMesh Satellite attempts to pair with the CloudMesh Gateway.
The LED flashes blue. When the Satellite has been paired with the Gateway, the LED will display as
solid white, blue, or red, depending on the signal strength.
I mportant –
If the LED is solid red, this means the signal is poor.
Reposition the Satellite closer to the Gateway.
Refer to
CloudMesh Satellite location section of this guide, above.
The CloudMesh Satellite is now ready to use.
Pairing via WPS push button
If the CloudMesh Satellite and the CloudMesh Gateway have not been set up by your Internet Service
Provider, you will need to pair them yourself. The CloudMesh Satellite can pair with a CloudMesh Gateway
using the WPS (Wi-Fi Protected Setup™) functionality.
1
Place the CloudMesh Satellite next to your CloudMesh Gateway.
2
Connect power to both devices, switch them on and wait for them to power on. If the CloudMesh
Satellite LED light is still flashing blue after 20 minutes, you will need to pair it with the CloudMesh
Gateway manually.
3
Ensure that the CloudMesh Gateway is connected to the Internet.
4
Press and release the WPS button on the rear of the CloudMesh Satellite. The LED on the CloudMesh
Satellite flashes purple to indicate that the WPS pairing window has started and will last for two
minutes.
5
Press and release the WPS button on the CloudMesh Gateway while the CloudMesh Satellite LED is
still flashing purple. The pairing process can take up to five minutes.