NetComm NS-02, User Manual, Page: 14 / 22

14 of 22
CloudMesh Satellite – User Guide
UG01350 v1.00 14 July 2021
If the CloudMesh Satellite is paired to a CloudMesh Gateway, you can access the web interface by typing its
unique hostname into the address bar of a web browser.
The unique hostname for each CloudMesh Satellite is defined in the following format:
http://NS-02- XXXX .local
Where XXXX is the last four digits of the Satellite’s unique serial number.
The CloudMesh Satellite’s serial number can be found on the label affixed to the bottom:
Figure 9 – Last four digits of the serial number
If the device is not paired, please first follow
Appendix B – Set CloudMesh Satellite IP to access web interface
to
set up a static IP for the Satellite and then continue from step 3b of this section, below.
To access the Satellite’s web interface:
1 Connect the supplied power adapter to the power port on the CloudMesh Satellite and plug the
power adapter into a power point. Turn on the power at the wall and allow 60 – 90 seconds for the
satellite to power up.
2 Connect the supplied Ethernet cable from one of the two yellow LAN ports on the bottom of the
CloudMesh Satellite to an Ethernet port on your computer.