www.rsl.com.au
PAGE 2 of 4
DSL Setup - NB3300
6. The web-based management system will open to the "OnePage setup screen". This is the first page that is
displayed when the web-based management system is opened and for a basic access, is the only page
required to be edited.
Configure the computer
Ensure that the computer is connected to the router, or connected to the network device (eg a hub) into which the
router is connected. Ensure the router is turned on. (see above).
Note: the following sets of configurations assume you will be using the router as the method for connecting to the
Internet, in routed mode. It is not for using the router in bridged mode.
1. Right-click on Network Neighborhood and select "Properties".
2. Select "TCP/IP". If it is not in the list it will need to be installed. This may require the Windows CD-ROM and
instructions are not provided here.
3. Select "Settings".
4. Put the following information in the appropriate tabs. If a tab isn't listed, it doesn't require changing.
•
IP: the computer's internal static IP. Must be filled in unless the computer accesses a DHCP server (either
the router or another computer). General recommendation for a generic IP address is
192.168.1.2
(the
router is, by default,
192.168.1.1
). If using DHCP select that.
•
Gateway: router IP address (by default,
192.168.1.1
)
•
DNS: RSL COM domain name server IP addresses, unless the customer is running domain name servers.
Configure the router
Default internal IP address:
192.168.1.1
Default username/password:
{blank}/admin
1. Open any web browser.
2. Type the internal IP address (eg
192.168.1.1
) into the address section and press "enter".
3. The "Username and password" box will appear.
4. Leave the username empty and type "admin" in the password.
5. Click
"OK".
1300 764 764
5888
