IFWA-661 Outdoor Wireless Antenna
–
Installation Guide
18 of 63
v1.0 September 20, 2019
© NetComm Wireless 2019
Assemble the Outdoor Wireless Antenna Power supply
weather seal
The Outdoor Wireless Antenna Power supply weather seal must be properly attached to prevent dust and water
from entering the Outdoor Wireless Antenna
’s housing.
To connect Ethernet cable via the Power supply weather seal:
1
Unscrew the weather cap and remove the rubber gasket.
2
Separate the rubber seal and the ferrule.
Figure 13 - Rubber seal and ferrule
3
Twist the neck for the seal counter-clockwise to remove it from the Outdoor Wireless Antenna. You should
now have 5 pieces of the weather seal.
Figure 14 - Weather seal in five parts
4
Place the Ethernet cable through the nut first, as shown below.
Figure 15 - Nut placed over Ethernet cable
