IFWA-661 Outdoor Wireless Antenna
–
Installation Guide
15 of 63
v1.0 September 20, 2019
© NetComm Wireless 2019
3
Remove the cap from the head of the Smart Antenna Tool and insert it into the console port as shown in the
picture below.
Figure 9 - Attached Smart Antenna Tool
Perform the site survey
Push the power button on the Smart Antenna Tool to turn it on. After a few seconds, the LEDs illuminate. On each
start up, the Smart Antenna Tool LEDs flash both red and green twice a second, indicating that the compass
requires calibrating. To calibrate the device, first isolate it from any magnetic field or metal structures (for example,
vehicles, the antenna pole, power lines, etc) and then rotate the unit fully through all three axes. See the diagrams
below.
The LEDs stop flashing when calibration has been performed successfully.
