Netberg Demos R130 M2, Manual

Page: 41 / 263

Installing hardware
28
2.4. Power Supply Unit
The R130 M2 server models support both single and redundant power supplies as shown in the
following illustrations.
DISCONNECT THE POWER SUPPLY UNIT FROM THE POWER SOURCE BE-
FORE REMOVING PSU. FAILURE TO DO SO COULD RESULT IN DAMAGE TO
THE EQUIPMENT OR PERSONAL INJURY.
The redundant power supply unit can be replaced without shutting down the system.
2.4.1. Removing a Power Supply Unit
1. Pull the PSU handle up to the open position.
Figure 2.14. Opening the PSU Handle
2. Press and hold the locking latch lever.
3. Pull the PSU from the system.
Figure 2.15. Removing the PSU
2.4.2. Installing a Power Supply Unit
Insert the power supply unit (PSU) into the system.