Installing the appliance in a cabinet or rack
You must install rails in your cabinet or rack and then slide the appliance onto the rails. If you have
an SG5660, you must also install the drives after installing the appliance.
Before you begin
•
You have reviewed the Safety Notices document included in the box, and understand the
precautions for moving and installing hardware.
•
You have the Installation and Setup Instructions for the appliance.
•
You have the E-Series installation instructions for the hardware.
Caution:
Install hardware from the bottom of the rack or cabinet or rack up to prevent the
equipment from tipping over.
Caution:
The SG5612 weighs approximately 60 lb (27 kg) when fully loaded with drives. Two
people or a mechanized lift are required to safely move the SG5612.
Caution:
The SG5660 weighs approximately 132 lb (60 kg) with no drives installed. Four people
or a mechanized lift are required to safely move an empty SG5660.
Caution:
To avoid damaging the hardware, never move an SG5660 if drives are installed. You
must remove all drives before moving the appliance.
About this task
Task
Description
Install the mounting rails
Install the mounting rails in the cabinet or rack.
See the E-Series installation instructions for the E2700 or the
E5600.
Install the appliance in the
cabinet or rack
Slide the appliance into the cabinet or rack, and secure it.
Note:
If you are lifting the SG5660 by hand, attach the four
handles to the sides of the chassis. You remove these handles
as you slide the appliance onto the rails.
24 | Hardware Installation and Maintenance Guide for SG5600 Appliances
Summary of Contents for StorageGRID SG5600 Series
Page 2: ......
