DNS/network and IP address for the controller you removed with the MAC address for the
replacement controller.
Note:
If the original controller did not use DHCP for the IP address, the new controller will
adopt the IP address of the controller you removed.
7. Bring the controller online using SANtricity System Manager:
a. Select Hardware.
b. If the graphic shows the drives, select Show back of shelf.
c. Select the controller you want to place online.
d. Select Place Online from the context menu, and confirm that you want to perform the
operation.
e. Verify that the seven-segment display shows a state of
99
.
8. Confirm that the new controller is Optimal, and collect support data.
Related information
NetApp E-Series Systems Documentation Center
Replacing hardware components in the storage controller
shelf
If a hardware problem occurs, you might need to replace a component in the storage controller shelf.
Before you begin
You have the E-Series hardware replacement procedure.
About this task
To replace the battery in the storage controller, see the instructions in this guide for replacing a
storage controller. Those instructions describe how to remove a controller from the appliance, remove
the battery from the controller, install the battery, and replace the controller.
For instructions for the other field replaceable units (FRUs) in the controller shelves, access the E-
Series procedures for system maintenance.
FRU
See instructions
Battery
StorageGRID (this guide): Replacing a storage controller
Drive
E-Series:
•
Replace drive (60-drive)
•
Replace drive (12-drive or 24-drive)
Power canister
E-Series
•
Replace power canister (60-drive)
•
Replace power supply (12-drive or 24-drive)
Fan canister (60-drive shelves only)
E-Series: Replace fan canister (60-drive)
Drive drawer (60-drive shelves only)
E-Series: Replace drive drawer (60-drive)
92 | Hardware Installation and Maintenance Guide for SG6000 Appliances
Summary of Contents for SGF6024
Page 2: ......
