NetApp E2600, Installation Manual

Page: 85 / 142

E2600 Controller-Drive Tray Installation Guide 77
Figure 70 Drive Tray Installed in the Cabinet
15. Slide the fan canister all the way back into the drive tray until the tab on the fan canister latches.
16. Attach the bezel onto the front of the drive tray.
Steps to Install – Drives on the DE6600 Drive Tray
The DE6600 drive tray is shipped with the drive drawers installed, but the drives are not installed. Follow the steps
in this procedure to install the drives.
ATTENTION Risk of equipment malfunction – To avoid exceeding the functional and environmental limits,
install only drives that have been provided or approved by the original manufacturer. Drives might be shipped but
not installed. System integrators, resellers, system administrators, or users can install the drives.
NOTE The installation order within each drawer is from left to right in rows. Slots 1, 4, 7 and 10 must have a drive
installed in these locations to make sure there is sufficient air flow to the drives. To verify these slots, consult the
overlay on the front of each of the five drive drawers. Make sure that the four drives in each row are adjacent to each
other. The long edge of each drive should touch the drive next to it. To maintain a uniform airflow across all drive
drawers, the drive tray must be configured with a minimum of 20 drives, with four drives in the front row of each of
the five drive drawers.