1
Lock-out tumbler
2
Drawer guide
2. Position the replacement drive drawer in front of the empty slot and slightly to the right of center.
Positioning the drawer slightly to the right of center helps to ensure that the lock-out tumbler and the drawer guide are
correctly engaged.
3. Slide the drive drawer into the slot, and ensure that the drawer guide slides under the lock-out tumbler.
Attention:
Risk of equipment damage – Damage occurs if the drawer guide does not slide under the lock-out tumbler.
4. Carefully push the drive drawer all the way in until the latch fully engages.
Note:
Experiencing a higher level of resistance is normal when pushing the drawer closed for the first time.
Attention:
Risk of equipment damage — Stop pushing the drive drawer if you feel binding. Use the release levers at the
front of the drawer to slide the drawer back out. Then, reinsert the drawer into the slot, ensure the tumbler is above the
rail, and the rails are aligned correctly.
Attaching the cable chains
When attaching a cable chain, reverse the order you used when disconnecting the cable chain. You must insert the chain's
horizontal connector into the horizontal guide rail in the enclosure before inserting the chain's vertical connector into the vertical
guide rail in the enclosure.
Before you begin
•
You have replaced the drive drawer and all of the drives.
•
You have two replacement cable chains, marked as LEFT and RIGHT (on the horizontal connector next to the drive drawer).
14
