netAlly EtherScope nXG Controlled Edition, User Manual

Page: 695 / 795

Running a Performance
Test
Note the following before running:
l
The Performance Test can only run from the
Wired Test Port (top RJ-45 or Fiber port),
and an AutoTest Wired Profile must connect
successfully to establish link on the port. If
you receive a Status message such as "The
wired test port is not linked" or "No IP
address" but you have an active network
connection, go to AutoTest and run a Wired
Profile to troubleshoot your connection.
l
All configured Performance Test Services are
tested at the same time. If one Service fails
to meet the thresholds for the test, the
entire test fails.
l
Only four Services can run at once. If you
have selected more than four Services in the
Performance Settings , the test fails with the
Status message, "Too many services enabled
(56)."
Performance Test App
695