1
Check if the water tank contains enough fresh drinking
water. Switch on machine. Power button starts blinking red
while machine is heating up for approximately 40 seconds.
Afterwards power button lights steady green. Machine is
ready to use.
2
Adjust drip tray position. Place cup with correct cup size on
drip tray. See 3. "BEVERAGE EXAMPLES" or package.
3
Open locking handle. Pull out capsule holder. Make sure
rinsing tool is not inside. Insert capsule in capsule holder.
Insert it back into machine. Close locking handle.
4
Push selection lever to the "HOT" or "COLD" position as
recommended on capsule packs. Beverage preparation
starts.
STOP
5
Stay beside the machine throughout the preparation!After
reaching the desired level push selection lever to the
“STOP” position. Machine stops preparation.
6
After finishing preparation the power button blinks red for
about 5 seconds.
During that time do not open locking
handle!
7
After extraction is finished remove cup from drip tray.
8
Open locking handle. Pull out capsule holder. Remove used
capsule. Put used capsule in dustbin.
9
Rinse capsule holder with fresh drinking water from both
sides. Dry capsule holder. Insert it back into machine.
Enjoy your beverage!
9
6.
PREPARING A BEVERAGE
6. 1 ONE CAPSULE (E. G. LUNGO)