Nerival NEO-100, User Manual

Page: 12 / 15

12
www.nerival.fi
Settings
Press the
▲
button to enter the setting mode.
Use the
▲
and
▼
buttons to select the setting you want to set.
Press the decrease or increase button to set the desired value.
To save the setting and exit the setting mode, press the button.
General settings 1-22
Setting
number
Function
Setting
range
Factory
setting
Additional information
1 Opening speed 0-30 20
The higher the value, the faster the
door opens
2 Closing speed 0-30 20
The higher the value, the faster the
door closes
3 Opening angle 0-99 20
The higher the value, the larger the
opening angle 45-180 degrees
4 Unlock delay 0-99 0
The lock is released first, after which
the door opens after a set delay of 0-
1 seconds
5 Door hold open time 0-99 1
0-99 seconds opening time after the
door has opened
6
Closing door anti-
collision delay
0-30 10
The smaller the delay, the faster the
door opens in a collision
7 Closing force 0-10 5
The higher the value, the greater the
closing force
8 Lock mode selection 0-4 1
1: The door opens by pushing /
pulling
2: -
3: Magnetic lock
4: Electric bolt lock
9 Opening direction 0-1 0
0: left
1: right
10
Adding a remote
control
0-40 0
see Adding a remote control
Additional controller
[80410] RCT-8100
or [33340] RCT-1224
11 Slow closing angle 0-50 0
The higher the value, the greater the
angle at which the door closes slowly
12 Slow opening angle 0-50 0
The higher the value, the greater the
angle at which the door opens slowly
13
Opening door anti-
collision delay
0-30 10
The lower the delay, the faster the
door stops in a collision
15
Closing speed after
reset
0-20 0 Closing speed after reset
16 *P1+ signal mode 0-1 0
Standard voltage signal input
Lock signal ends
17 *P1, P2 Port function 0-2 0
P1 Automatic switch
P2 Forced off