Model: 37755-TRU/ 37756-TRU
1.0 Installation.
1.1 Removing the Belt Clip
a. Pull the Belt Clip latch forward
(away from the FX-250)
b. While pulling the Belt clip pertinent
latch, push up the Belt clip as
shown in Figure1.
1.2 Installing the Belt Clip
a. Slide the Belt clip into the
slot A “click” indicates the Belt
clip is locked into position.
2.0
Installing the Batteries
Caution: Observe the proper battery polarity orientation when
installing batteries. Incorrect positioning can damage both the
batteries and the unit.
a. Pull up on the battery door latch to remove the battery compartment door.
b. Install the rechargeable batteries by following the orientation as
shown in Figure 3 (the arrow is showing and pointing upward.)
c. Replace the Battery compartment cover. See Figure 4.
Important
-Read these Safety Warnings before you charge the batteries.
-When placing the 37755-TRU in the charger, use only the power supplies listed in the user
instructions supplied with the 37755-TRU.
-
Don’t try to recharge non-rechargeable batteries.
-Make sure the battery compartment cover is securely locked in place when you are charging
the batteries.
-Dispose of used batteries safely and in a way that will not harm the
environment, never try to burn them or put them anywhere, they could get burnt or punctured.
- Risk of explosion if battery is replaced by an incorrect type.
USER GUIDE
