Nera WiLink-I 3000, System Manual

Page: 146 / 250

126 Operation
Chapter 4 - Operation and Administration
¢
Status
¢
Reset
¢
Set Factory Defaults
¢
SW Version Control
4.9.6.2.1 SU Status
The SU Status parameter enables defining the status of the SU, which determines
the services it can receive.
The available options are:
1 - Permanent
2 - Temporary
4.9.6.2.2 Reset Unit
Select this option to reset the unit. To avoid unintentional reset, you will be
prompted to confirm the reset request. Changes to some of the configurable
parameters are applied only after reset. Refer to
Section 4.11 for information on
which parameters are changeable in run time and which changes are applied only
after reset.
4.9.6.2.3 Set Factory Defaults
Select this option to set the SU parameters to their factory default values. Refer to
Section 4.11 for information on the factory default values of these parameters.
The parameters will revert to their default values after the next reset.
4.9.6.2.4 SW Versions Control (only for Permanent SUs)
The SU can contain two SW versions:
¢
Main: Each time the SU resets it will reboot using the version defined as Main.
¢
Shadow: Normally the Shadow version is the backup version. Each time a new
SW File is downloaded to the SU, it will be stored as a Shadow version,
replacing the previous Shadow Version.
NOTE
An SU that is defined as Temporary will be deleted from the database when it is disconnected.