Nera Saturn Bt, Operator'S Manual

Page: 62 / 122

Saturn B – Chapter 3. Configuration 3.10
General
The Incoming Call route function no. 71 is used to link a received call
to the wanted end terminal connector(s). As a default, the HANDSET,
TEL.1, and TEL.2 connectors have been set up with a standard pair
of OI/DIs,
see previous page . (E.g., an incoming call with an IMN
containing DI no.17 is routed directly through to connector TEL.2).
Setting Call Route
The connectors TEL.3 through TEL.5 have no default settings and
must be provided with the appropriate DI.
Note that if changing a call
route, you may be prompted to delete the current setting first.
Example:
1
Select INCOMING
CALL ROUTE function ( 71 ):
2
ENTER list of DIs:
3
Key in new DI, e.g. 3 :
4
Key in service type:
1=telephone (TPH), 2=telefax (FAX)
4=telex (TLX), 5=high speed data (HSD)
5
Set the routing to
e.g. TEL.3 only:
H : Handset connector
1, 2, 3, 4, 5 : Telephone/telefax connectors
P : Not used in Saturn B
Setting=1
: IMN with DI is routed to device
Setting=
*
: IMN with DI is not routed to device
Note! A call can only be routed to a connector with the same service type as
that of the call. For other services such as telex or data communication and
high speed data transfer, see separate manuals for these settings.
Note down all settings in the list provided in
appendix F .
6
Check entries:
and revert to IDLE:
Incoming Call Route
Incoming Call Route *
ON
RING H12345P
ON 1
1
ABC
FUNC
ON
7
STU
3
GHI
1
ABC
DATA
ØÅ.
DATA
ØÅ.
DATA
ØÅ.
1
ABC
INCOMING
CALL ROUTE
71
DI
Service
ON
TELEPHONY
1
ON
0
3
ON
SERVICE
1
3
ENTER
ENTER
ON
TELEPHONY
3
ENTER
ESC
3x
ENTER
ENTER
ENTER