WP-Series Reverse Osmosis System
Installation Instructions and User Manual
Page | - 6 -
RO System Specifications
Table 1 - RO System Electrical Specifications
Model
Hz
Motor HP
Volts
Phase
WP25211-116
60
1/3
115/230
1
WP25211-215
50
1/3
220/230
1
WP25211-216
60
1/3
220/230
1
WP25212-116
60
1/3
115/230
1
WP25212-215
50
1/3
220/230
1
WP25212-216
60
1/3
220/230
1
WP25213-116
60
1/3
115/230
1
WP25213-215
50
1/3
220/230
1
WP25213-216
60
1/3
220/230
1
Operational Notes
1. All
systems rated at 77 Degrees Fahrenheit (25 Degrees Celsius) using 1000 ppm sodium chloride (NaCl)
solution. System capacity decreases significantly with decrease in feed water temperature (see temperature
correction chart).
2. Chlorine requirements for the feed water are as follows:
Thin-Film (standard)
0
ppm
CA (special order only)
0.1
ppm Minimum
3. Feed water must be filtered to a turbidity of less than 1 NTU.
4. System recovery (permeate to concentrate ratio) must be maintained at the recommended level. A higher than
recommended recovery will lead to a premature fouling of the membrane with a loss of permeate flow and permeate
quality.
5. Softened water should be used for the feed water to the RO system.
Summary of Contents for WP Series
Page 31: ...Notes ...
