6.1.2
Selecting a PCB
1. Accessing the PCB selection menu.
Important
The PCB selection menu is available only when the icon flash
es.
2. Scroll through the names of the connected additional PCBs by
pressing the or keys.
The names of the installed PCBs will be displayed in sequence.
3. Confirm the required PCB by pressing the
key.
4. Go back to the main display by pressing the
h
key.
For more information, see
COUNTERS / TIME PROG / CLOCK menus, page 26
Modifying the User parameters, page 27
6.2
Start-up
If the boiler was powered off:
1. Check that the heating system and the boiler are adequately primed
with water. Recommended pressure: 0.15 MPa (1.5 bar).
2. Check that the storage tank is filled with fuel.
3. Open the oil inlet valve.
4. Switch on the boiler.
A venting cycle is run automatically.
The display shows the operating status of the boiler, the heating flow tem
perature and any error codes.
6.3
Shutdown
6.3.1
Switching off the heating
Note
Heating mode can be managed via the TIME PROG sub-menu
dedicated to timer programming.
1. Go to stop mode by pressing the
key.
2. Select the heating mode by pressing the key.
3. Confirm by pressing the
key.
Fig.25
MW
-5
0
0
0
1
3
7
-2
MW
-5
0
0
0
1
3
7
-2
Fig.26
MW-5000027-4
Fig.27
MW-5000133-3
6 Utilisation with the control panel IniControl 2
7641178 - v02 - 17102016
EFU FF
19
