Neomatica LLC. Vehicle tracker ADM333BLE GLONASS/GPS. Ver. 1.2 dd 13.07.2019
16
TRACKSET 4
High tracking detalization. Slight changes in direction are drawn with many details. (expected
points per km are 1.6 times more than in preset 2)
5.6.2 Expert setting of tracking parameters.
It is recommended to use this method of setting only if none of the presets fit the task. The
change of these parameters can lead to an increase of traffic consumption or to a decrease of the
route drawing quality.
• Setting using TRACK command
To set all the parameters send TRACK command twice. The degree of road turns detalization
is set by sending TRACK command with three parameters. Command format: TRACK M,A,B
The threshold values of additional circumstances of route points drawing in movement are set
by sending TRACK command with four parameters. Command format: TRACK 255,X,Y,Z
• Setting the degree of road turns drawing detalization. Setting threshold values of angle
change and deflection.
A route point is drawn when the threshold values are exceeded.
TRACK M,A,B
M
– number of speed mode.
M=255
– apply same parameters for all the modes
M=0
– slow movement
M=1
– medium -speed movement
M=2
– fast movement
A
– angle for speed mode with M number.
B
– deflection for speed mode with M number.
The threshold values of angle change and deflections are set separately for three speed
modes. If same values should be set for all speed modes then the command should be sent once,
M parameter in this case equals to 255. If different threshold values should be set for three speed
modes then the command should be sent 3 times, choose speed mode using M parameter.
Example
•
Setting same parameters for all speed modes:
TRACK 255,10,6
– Set 10 degrees for the threshold value of route change and 6 for deflection
• Setting different parameters for all speed modes:
