Neomatica LLC. Vehicle tracker ADM333BLE GLONASS/GPS. Ver. 1.2 dd 13.07.2019
14
5.4 Setting connection to the server
Configure the IP address and port of the server (host) using «
SETHOST0
» or "
DN0
" command.
Change of these parameters is possible in the graphical interface of the program "ADM
Configurator".
5.5 Setting data transmission
Navigation data and data received from different sensors being transmitted from the tracker to
the server, are divided by data packets. Depending on the functionality used, it is necessary to
activate the transmission of the necessary data packets.
The setting is done in the graphic interface of the ADM Configurator or by
PROTOCOL
command.
Table 1 shows the correspondence of data packets to the values of
PROTOCOL
command. If
data transmission is required to be transmitted from several packets then calculate
PROTOCOL
command parameter by addition. To save the traffic it is recommended to set only the transmission
of necessary data packets.
For example:
Main data (0) +analogue inputs (8) +fuel level sensors (32) = PROTOCOL 40
Table 1. Values of the main parameters for PROTOCOL command
Data packet name
Parameter value
Main data
NAVIGATION DATA
0
Outputs, events in inputs
OUTS
4
Analogue inputs
IN_A
8
Fuel level sensors
FUEL
32
Can
CAN
64
