Page 3 / 3
Product Installation:
Step 1: Open the base frame, and insert guide post of the base frame into the hole on the
outer ring, and fix the base with screws; (Figure 1 and Figure 2)
Step 2: Insert the 3-sections center supporting tube into the hole at base frame; (Figure 3)
Step 3: Insert the Star into the iron frame hole at the top of the lamp body; (Figure 3)
Step 4: Insert the iron frame of lamp body into the center supporting tube; (Fig. 3)
Step 5: Open the reeled lamp body and pull down the lamp body to be straight, and insert the
pin into the T-joint hole and the outer ring hole of the base; (Figure 4)
Step 6: If the product is placed outdoors, please hook one end of the hook to the outer ring of
the base and one end to the ground; (Figure 5)
Step 7: Connect the connector of the lamp body to the connector on the controller; (Figure 5)
Step 8: Power on.
Figure 1 Figure 2 Figure 3 Figure 4
Figure 5
Maintain and Care
You should maintain and care for the tree light kit in the following areas before storage.
1. Clean and wipe all the metal parts. Use rust removal product (not included) such as WD-40 to clean
any rusty spots if there is any when powder coating is damaged. (Note: Follow the rust removal
product instructions when using it.)
2. Repaint any spots where the paint on the metal part is damaged. (Note: Paint not included)
3. Clean and wipe the light strands and all other parts. (Important: DO NOT let any part of this product
submerge or soak in water.)
4. Be sure all parts are dry before storage.
1
2
3
4
5
7
8
9
6
10
11
