⬥
anchor holes
⬥
holes in concrete
⬥
holes in tile
Choose the rotation-only function to:
⬥
drill holes in steel or wood
⬥
tighten machine screws and wood screws
Choose the hammering-only function for:
⬥
Light concrete chiseling
⬥
groove digging
⬥
edging
Tips for Use
♦
Always put the bit in contact with the surface you’re working
on prior to pulling the trigger for maximum control.
♦
Always hold the rotary hammer firmly and use moderate, even
pressure. Applying too much pressure, especially at lower
speeds, will cause the hammer to stall. Utilizing too little
pressure or uneven pressure can cause the bit to skip and slide
over the surface and/or prevent it from cutting through the
work surface.
♦
Wipe the shanks of the bits clean prior to installation and
immediately after removing them from the rotary hammer.
Maintenance
Rotary Hammer Care
♦
When working in cold weather or when operating the tool after
it has been stored for a long time, run the tool under no load
for several minutes. This lubricates the tool and warms it up. If
it is not properly warmed and lubricated, the rotary hammer
will be difficult to operate.
15
Summary of Contents for RH-22-6Li-50
Page 1: ......
