Page | 7
P: 419.542.7751 F: 419.542.6690 800.782.761 nemcofoodequip.com
49232A
Temperature Control Mode
If you purchased the optional Temperature Probe, you can use this unit in Temperature
Control Mode.
1.
Plug the temperature probe into the jack on the back of the unit. Tighten the
screw-ring to secure the probe in the connector.
2.
Place the probe in the pot. Make sure the probe is in the liquid, but not touching
the bottom of the pot.
3.
With the unit in the Ready state, press the ‘MODE’ button. The display will show
‘000F’.
4.
Press the ‘Start/Stop’ button. The unit will turn on, and the display will show
‘100F’.
5.
Use the ‘ʌ’
up
and ‘v’ down buttons to set the desired temperature in degrees
Fahrenheit.
6.
The display will alternate between the actual temperature and your set point.
7.
When the food temperature reaches the set point, the display will lock on the
actual temperature. The unit will cycle as necessary to maintain the set point
temperature.
8.
Timer Mode
The timer function allows you to set a timer from 1 second, up to 719 minutes. The
timer resets to 719 minutes every time the power is turned off/on. The timer always
runs in the background, so if the unit runs continuously for 12 hours (719 minutes), the
timer will run out and the unit will turn off. To reset, turn the power off/on, or
manually set the timer.
Setting the Timer
With the unit powered on and in the Ready state
(display shows a steady ‘00’),
press the ‘TMR’ button. The display will show ‘
07
19’
.
To change the timer setting, press the
‘MIN/SEC’ button. The display will flash
‘719’.
Use the ‘ʌ’ up and ‘v’ down buttons to adjust the nu
mber of minutes. Pressing
the ‘v’ button will reduce the number of minutes. If you press the ‘ʌ’ button
past
719,
the display will go to ’00.59’ or 59 seconds. Keep pressing the ‘ʌ’ button to
increase the minutes.
