Nelson N800iTM, Operation And Service Manual, Page: 19 / 142

Tucker GmbH, Mail / Post: Max-Eyth-Str.1, 35394 Gießen, Germany
Stud welding unit N800i
As of 24.08.2021
Manual part number: BE 1227
15
2. Safety at work
2.1 Safety Symbols
Safety notices and warnings are made on the one hand for your personal safety and
on the other hand for product safety. In these operating instructions they are made
to stand out by means of the following safety symbol.
The applied symbol has the following meaning:
The caution sign draws your attention to potentially dangerous
situations. It is always used in connection with one of the
supplementary terms which are defined as follows.
The used supplementary terms have the following meaning:
Warning!
The system operator is obliged only to allow persons to work with the unit,
who are acquainted with the safety at work and accident prevention
regulations and have a training authorizing them to perform stud welding!
All persons who work with the unit are obliged to read and observe all the
operating and service instructions of the welding unit prior to
commencing work! In addition, the operating instructions of the weld gun
connected in each case must be read and observed!
Danger
The addendum means that death, grievous bodily harm or
considerable damage to property will occur if the
corresponding preventive measures are not taken.
Warning
The addendum means that death, grievous bodily harm or
considerable damage to property can occur if the
corresponding preventive measures are not taken.
Caution
The addendum means that slight bodily harm or damage to
property can occur if the corresponding preventive measures
are not taken.
This sign contains important information about the correct
method of handling the product or special advice, to which
particular reference is to be made.