DIRECTIONS FOR
SinuGator
®
Cordless Pulsatile Nasal Wash
The
Neil
Med
®
Sinu
gator
®
cordless Pulsating
Nasal Wash
™
is an easy to use system that
allows you to deliver the saline solution
with positive and pulsatile pressure to
clean the nasal passages thoroughly.
Step 1:
Please wash your hands. Fill the clear
blue reservoir with 240 mL (8 fl oz) volume of
lukewarm, distilled, micro-filtered (0.2 micron)
or previously boiled and cooled down water.
Step 2:
Cut the
SINUS RINSE
™
mixture
packet at the corner and pour its contents
into the blue reservoir of the
Sinu
gator
®
.
Place the white motor unit over the blue
reservoir and rotate until locked. Swirl the
unit thoroughly to dissolve the mixture.
Step 3:
Standing in front of a sink, bend
forward to your comfort level and tilt your
head down. Keeping your mouth open,
without holding your breath, place the tip
snugly against your right nasal passage
or nostril. Press the blue power button
until the solution starts draining from
your left nasal passage. Depending on
the head position, residual solution may
drain from your mouth. We suggest to
spit it out, however, there is no harm, if
accidentally swallowed. For a proper
rinse, keep pressing the power button
until at least 1/4 to 1/2 (60 mL to 120
mL or 2 to 4 fl oz) of the solution is used
for one nostril. Stop pressing the power
button if you feel any discomfort, pain
or pressure during the irrigation.
Step 4:
Blow your nose very gently,
without pinching nose completely
to avoid pressure on eardrums. If
tolerable, sniff in
gently any residual
solution remaining
in the nasal
passage once or
twice, because
this may clean
out the posterior nasopharyngeal area,
which is the area at the back of your nasal
passage.
Step 5:
Now repeat steps 3 and 4 for
flushing your left nasal passage or nostril.
Cleaning Directions:
Clean the
Sinu
gator
®
by running plain water and dry
with a clean lint free towel and then air dry the unit by
keeping it open to the air. The nasal irrigator tip, blue
reservoir and white soft tube can be disinfected by
placing in the home microwave for 60 seconds. (Read
additional details in enclosed brochure.) Clean the
entire unit with a few drops of dishwashing liquid and
water every three days to keep the unit clean. Please
make sure to run enough water during each wash so
no soap is left behind
Directions for Assembly:
Step 1:
Open the battery compartment by sliding
the switch to the left (open position), lift up the panel
and place 3 AA batteries as shown inside the battery
compartment. Replace the panel and slide the switch
to the right (locked position).
Step 2:
Slide the white soft tube over the white rigid
tube on the bottom of the motor unit.
Step 3:
Attach the nasal irrigator tip to the top of the
motor unit.
Step 4:
Press the blue switch to make sure unit is
operating.
Cordless Pulsating
Nasal Wash
SCAN THIS QR CODE*
to get discounts,
directions and
videos
