Cleaning and servicing
en
21
Cleaning the grease filters manually
1.
Remove the components of the grease filter.
2.
Soak the grease filter in hot soapy water.
‒
Use a brush to clean the grease filter. Do not use
aggressive, acidic or alkaline cleaning products.
‒
Use special grease solvent for stubborn dirt. You
can purchase the grease solvent from Customer
Service, through our online shop or in a special-
ist shop.
3.
Rinse the grease filters thoroughly.
4.
Leave the grease filter to drain.
5.
Fit the components of the grease filter.
6.
After drying, insert the grease filter into the appli-
ance.
Cleaning the grease filter in the dishwasher
1.
Remove the grease filter.
2.
Remove the components of the grease filter.
3.
Place the components of the grease filter loosely in
the dishwasher and do not jam them in.
‒
Do not clean heavily soiled grease filters with
tableware. Do not use aggressive, acidic or al-
kaline cleaning products.
4.
Start the dishwasher. Select a maximum temperat-
ure setting of 70 °C.
5.
Leave the grease filter to drain.
6.
After drying, insert the grease filter into the appli-
ance.
24.5 Odour filter or acoustics filter
You can obtain odour filters or acoustics filters from
specialist retailers, customer service or in the online
shop.
Notes
¡
Replace the odour filters when the warning is dis-
played on the appliance.
"Resetting the saturation indicator", Page 21
¡
Change the acoustics filters if they are dirty.
Requirement:
To keep them in good working order,
only use genuine replacement filters.
1.
Remove the grease filter.
2.
Remove the four odour filters or acoustics filters,
and dispose of them properly.
3.
Insert two new odour filters or acoustics filters into
the left and right of the appliance and slide them for-
wards.
4.
Insert the other odour filters or acoustics filters into
the left and right of the appliance.
5.
Insert the grease filter into the appliance.
Resetting the saturation indicator
After the appliance is switched off, lights up.
1.
Replace the odour filters.
"Odour filter or acoustics filter", Page 21
2.
Press and hold the ventilation sensor until a signal
tone sounds.
a
stops lighting up. The odour filter display is reset.
24.6 Cleaning the overflow container
The overflow container collects liquids or objects that
come into the appliance from above.
Requirement:
The appliance has cooled and the resid-
ual heat indicator has gone out.
