26
Time programming function
This function may be used in two different ways:
■
to automatically switch off a hotplate.
■
as a timer.
Turning off a hotplate automatically
Enter the cooking time for the required hotplate. The hotplate
turns off automatically once the time has elapsed.
How to program
The range should be switched on.
1.
Select the hotplate using the Tipp control.
2.
Press the
3
symbol.
‹‹
is displayed in the time program
function display. Select the required cooking time using the
Tipp control.
After a few seconds the cooking time begins to count down.
Once the time has elapsed
The plate is turned off. The warning signal sounds, the hotplate
displays
‹
and the time program function screen displays
‹‹
for one minute. The
x
indicator of the hotplate flashes.
Pressing any symbol turns off the indicators and stops the
beep.
Changing or cancelling the time
select the hotplate using the Tipp control. Press the
3
symbol
and change the cooking time using the Tipp control, or set
to
‹‹
.
Notes
■
If cooking times have been programmed for various plates,
the time program function displays the shortest cooking time.
The
x
indicator of the hotplate lights up.
■
To check the remaining cooking time of a hotplate: select the
hotplate using the Tipp control. The cooking time will be
displayed for five seconds.
■
Cooking time can be programmed for up to 99 minutes.
Automatic timer
With this function you may select a cooking time for all
hotplates. Once a hotplate is switched on, the selected time will
begin to count down. The hotplate will automatically switch off
when the cooking time has elapsed.
Instructions on activating the timer are found in the chapter
entitled "Basic settings".
Note:
The cooking time of a plate may be cancelled or
changed:
Select the hotplate using the Tipp control. Press the
3
symbol
and change the cooking time using the Tipp control, or set to
‹‹
.
The timer
The timer can be set for periods of up to 99 minutes. It is
independent of the other settings. This function does not
automatically switch off a hotplate.
How to program
No hotplate should be selected.
1.
Press on the
3
symbol, and the time program function
display shows
‹‹
.
2.
Select the required time using the Tipp control.
The timer starts to count down after a few seconds.
Once the time has elapsed
A warning beep sounds. The time program function displays
‹‹
and the indicator
V
comes on. Pressing any symbol turns
off the indicators and stops the beeping.
Changing or cancelling the time
Press the
3
symbol and change the time using the Tipp
control, or set to
‹‹
.
Automatic time limitation
If the hotplate remains in use for a long time and no changes
are made in the settings, the automatic time limitation function
is triggered.
The hotplate stops heating. On the hotplate display,
”
and
‰
flash alternately.
The indicator goes out when any symbol is pressed. The
hotplate can now be reset.
When the automatic time function is used, it is governed by the
selected power level (from 1 to 10 hours).
Cleaning lock function
Cleaning the control panel while the hob is on may change the
settings.
In order to avoid this, the hob has a cleaning lock function.
Press the
"
symbol. A signal sounds. The control panel is
locked for 35 seconds. The surface of the control panel can
now be cleaned without risk of changing the settings.
Note:
The lock does not affect the main switch. The hob may
be switched off when desired.
