Hood connection
en
67
3.
Touch the
U
symbol repeatedly until the
™‚‡
setting appears.
‹
lights up in the hotplate display.
4.
Set the value to
‚
using the twist knob.
‚
flashes in the hotplate display.
5.
You have two minutes to initiate the connection
process on the extractor hood.
Once the hob is connected to the extractor hood, the
value
„
appears in the hotplate display. After you exit
the settings menu, the symbols for the hob-based hood
controls are displayed in the hob's control panel.
Connecting via your home network
You require a router that has WPS functionality.
You require access to your router.If you do not have
this, follow the steps for "Direct connection".
When you begin, make sure that the extractor hood is
connected to the app or is on your home network.
1.
Switch on the hob.
2.
Touch the
U
symbol for 4 seconds.
The product information will be displayed.
3.
Touch the
U
symbol repeatedly until the
™‚‡
setting appears.
‹
(not connected) or
ƒ
(connected to home
network) will be lit on the hotplate display.
4.
Set the value to
‚
using the twist knob.
‚
will flash on the hotplate display.
5.
If the appliance is not yet connected to your home
network, press the WPS button on the router within
the next 2 minutes.
The hob will be connected to your home network
and the value
ƒ
will appear on the hotplate display.
The process of connecting to the extractor hood
starts automatically and is active for 2 minutes.
If the appliance is already connected to your home
network, proceed to the next step.
6.
Initiate the process for connecting to the extractor
hood.
Once the connection process is complete, the value
„
will appear on the hotplate display.The symbols for the
hood controls on the hob are displayed on the hob's
control panel.
Note:
Connection can only be established when both
appliances are connected to your home network and
the connection process has been initiated for both of
them. If the connection process has already timed out
for one of the two appliances, try to connect again
(basic settings,
™‚‡
setting).
Resetting connection
You can reset the connections you have saved for your
home network and extractor hood at any time.
1.
Touch the
U
symbol for 4 seconds.
The product information will be displayed.
2.
Touch the
U
symbol repeatedly until the
™‚‡
setting appears.
3.
Set the value to
‹
using the twist knob.
Control the hood via the hob
In the basic settings of your hob you can adjust the
behaviour of your extractor hood depending on the
switch-on/off of the hob or individual cooking zones.
"Hood control settings" on page 68
You can select other settings using the control panel.
Setting the fan
Switching on
Touch the
A
symbol.
Setting fan level
Use the twist knob to select the fan setting.
You can choose between the levels 1, 2 and 3. To
select the intensive levels, turn the twist knob until
˜‚
or
˜ƒ
appears.
Switching off
Use the twist knob to select fan setting 0.
Setting automatic mode
Switching on
1.
Touch the
A
symbol.
2.
Turn the twist knob until the
‘
symbol appears on
the control panel.
The fan starts up automatically when steam is
produced.
Switching off
1.
Touch the
A
symbol.
2.
Turn the twist knob until the fan setting 0 has been
selected or choose another fan setting.
Setting the hood lighting
You can switch the hood light on and off via the hob's
control panel.
Touch the
6
symbol.
Summary of Contents for T16TS7KN
Page 2: ...2 cm 7 76 1...