NEFF T T 3 Series, Instruction Manual

Page: 30 / 52

30
Accessing the basic settings
The hob must be switched off.
1.
Switch on the hob.
2.
Within the next 10 seconds, touch the 3 symbol for 3
seconds.
™‚
and
‹
light up as a preset in the displays.
3.
Touch the 3 symbol repeatedly until the required function
appears in the display.
4.
Then select the required setting with the twist knob.
5.
Touch the
3
symbol for at least 3 seconds.
The settings have been saved.
Quit
To leave the basic settings, turn off the hob at the main switch.
Care and cleaning
The advice and warnings contained in this section aim to guide
you in cleaning and maintaining the hob, so that it is kept in the
best possible condition
Hob
Cleaning
Clean the hob after each use. This prevents food remains left
on the surface from burning. Wait until the hob is cool enough
before attempting to clean it.
Only use cleaning products specifically designed for hobs.
Follow the instructions provided on the packaging.
Do not use:
■
Undiluted washing-up liquid
■
Dishwasher detergent
■
Abrasive products
■
Corrosive products such as oven sprays or stain removers
■
Sponges that may scratch
■
High-pressure or steam cleaners
The best way to remove stubborn stains is to use a glass
scraper. Follow the manufacturer's instructions.
Suitable glass scrapers can be obtained through the Technical
Assistance Service or from our online shop.
Hob frame
In order to avoid damage to the hob frame, follow the
indications below:
■
Use only slightly soapy hot water
■
Do not use sharp or abrasive products
■
Do not use a glass scraper
The Tipp control
For cleaning the Tipp control, warm water and a little soap is
recommended. Do not use abrasive or corrosive cleaning
products. Do not clean the Tipp control in a dishwasher or in
washing up water. Otherwise, it could be damaged.
Fixing malfunctions
Malfunctions are generally caused by minor faults. Before
contacting the Technical Assistance Service, ensure you have
read the following recommendations and warnings.
Indicator Malfunction Measure
none The electric power supply has been cut off. Check other electrical appliances to check whether there has been a
power cut.
The appliance has not been properly con-
nected following the connection diagram.
Check that the appliance has been connected properly according to
the connection diagram.
Electronic system malfunction. If the malfunction is not resolved by the above checks, contact the
Technical Assistance Service.
“
flashing
The control panel is wet or an object is
resting on it.
Dry the control panel area or remove the object.
* If the indicator persists, call the Technical Assistance Service.
Do not rest hot pans on the control panel.