NEFF N D30 Series, Instruction Manual, Page: 24 / 40

24
Care and cleaning
The advice and warnings contained in this section aim to guide
you in cleaning and maintaining the hob, so that it is kept in the
best possible condition
Hob
Cleaning
Clean the hob after each use. This prevents food remains left
on the surface from burning. Wait until the hob is cool enough
before attempting to clean it.
Only use cleaning products specifically designed for hobs.
Follow the instructions provided on the packaging.
Do not use:
■
Undiluted washing-up liquid
■
Dishwasher detergent
■
Abrasive products
■
Corrosive products such as oven sprays or stain removers
■
Sponges that may scratch
■
High-pressure or steam cleaners
The best way to remove stubborn stains is to use a glass
scraper. Follow the manufacturer's instructions.
Suitable glass scrapers can be obtained through the Technical
Assistance Service or from our online shop.
Hob frame
In order to avoid damage to the hob frame, follow the
indications below:
■
Use only slightly soapy hot water
■
Do not use sharp or abrasive products
■
Do not use a glass scraper
Fixing malfunctions
Malfunctions are usually due to small details. Before calling the
Technical Assistance Service, you should consider the
following advice and warnings.
Indicator Malfunction Solution
none The electric power supply has been cut off. Use other electrical appliances to check whether there has been a
power cut.
The appliance has not been correctly con-
nected following the connection diagram.
Check that the appliance has been connected correctly according to
the connection diagram.
Electronic system malfunction. If in the above checks, the malfunction is not resolved, contact the
Technical Assistance Service.
“ flashes
The control panel is damp or an object is
resting on it.
Dry the control panel area or remove the object.
Ҥ
+ number /
š + number /
¡
+ number
Electronic system malfunction. Unplug the hob from the mains. Wait about 30 seconds before plug-
ging it in again. *
”‹ / ”Š
There is an internal error in the working. Unplug the hob from the mains. Wait about 30 seconds before plug-
ging it in again. *
”ƒ
/
Ӡ
The electronic system has overheated and
the corresponding hotplate has been
switched off.
Wait until the electronic system has cooled down completely. Then
push any symbol on the hob.*
”…
The electronic system has overheated and
all hotplates have been switched off.
—‚
Supply voltage outside normal operating
limits.
Please contact your electricity board.
—ƒ / —„
The hotplate has overheated and has
switched off in order to protect its cooking
surface.
Wait until the electronic system has cooled down sufficiently before
switching it back on.
* If the warning persists call the Technical Assistance Service.
Do not rest hot pans on the control panel.